Wi-Fi Configuration And Product Registration Via The App (User) - elco REMOCON NET MINI Installation And Operating Instructions Manual

Wi-Fi configuration and product registration via the App (User)

1. Use the account previously created to
enter the app.
If there aren't any paired products, a
screen will appear asking the user
whether they would like to add a new
product; press "add".
4. The app will suggest the Wi-Fi
network and will ask the user to enter
the password. If the network is incorrect,
click on the name of the network and
choose the correct network from the list.
Enter the password and continue
2. This is followed by a question about
the product's connection status; if the
product has never been connected to
the Wi-Fi network, choose "I want to
connect the product now", otherwise if
the product is already connected to a
Wi- Fi network, choose "The product is
already connected"
5. Tap the lens icon to enter the correct
address
WARNING: accuracy is important for the
correct operation of certain services
If the result is unsatisfactory, drag the
cursor to the exact position and enter
the correct address in the "address" field
Choose a name for your system and
that's it!
45
3. Hold the AP button down for at least
5 seconds until the WEB led starts
flashing green. After at most
40 seconds, the gateway will create
a new Wi-Fi network which will remain
active for 10 minutes, after which the
procedure must be repeated.
Confirm that you have started the
connection procedure on the product.
The app will ask for permission to
connect to the "Remote Gw Thermo"
network; give your consent to continue
the connection procedure.
6. That's it, you are ready to go!
The procedure is successful if the BUS
and WEB LEDs are both solid green.
ATTENTION!
If your smartphone keeps disconnecting
from the network of the product, please
check the Wi-Fi settings of your smart-
phone and make sure that automatic
network selection is disabled.
en