2,500 psi. service manual are fully understood. General Description The Lincoln Industrial rotary DC electric pump uses a 24VDC motor and either a single a double stage planetary gear drive. Grease output is proportional to the pump RPM.
Installing the Pump Typical installation is shown only as a guide for selecting and installing system components. Contact your Lincoln Mount the pump securely on the drum cover. Failure to Industrial representative for assistance in designing a do so could result in personal injury and equipment system to suit your specific needs.
16.Using a 1/2” wooden or plastic rod, push the cup seal (21) and the pump cylinder (23) from the reciprocating Always use Lincoln Industrial parts for service and repair. tube (20). 17.Remove the pump plunger (19) from the plunger link Crank Case Oil rod (16).
Page 6
FlowMaster™ Rotary Driven Electric Pump Pump Assembly Procedure 1. When the pump is dissembled, it is recommended to 10.Fill crankcase with SAE 10W30 motor oil up to the center replace all seals and gaskets, which are included in the of the pump shaft (37) before fastening housing cover 270663 repair kit.
Page 7
FlowMaster™ Rotary Driven Electric Pump MODEL DIM "A" in (mm) DIM "B" in (mm) 85567 27.50 (699) 35.00 (889) 85568 19.00 (483) 26.60 (676) 85569 13.69 (348) 21.25 (540) Illustration #3 Form 422734 Page Number - 7...
Page 8
FlowMaster™ Rotary Driven Electric Pump Illustration #4 Page Number - 8 Form 422734...
FlowMaster™ Rotary Driven Electric Pump Repair Parts List (Common to all Models) Item No. Qty Description All Models Item No. Qty Description All Models Flat Head Screw O-Ring 272567 (1/4 x 1-3/4) 270635 Pump Shaft 272548 Counter Weight 272197 Ball Bearing 272556 Retaining Ring 270609...
Need help?
Do you have a question about the FlowMaster A Series and is the answer not in the manual?
Questions and answers