Safety Information - EMC Iomega StorCenter ix2-dl User Manual

Iomega StorCenter ix2-dl User Guide

Safety Information

Observe the following guidelines when using your Iomega StorCenter ix2-dl :
1. Follow all instructions marked on the StorCenter ix2-dl and in the documentation.
2. Use only the power supply cable provided with the StorCenter ix2-dl . Always use the
appropriate power supply cable for your country.
3. Unplug the StorCenter ix2-dl before cleaning. Do not use liquid or aerosol cleaners. Use a
damp cloth for cleaning.
4. Do not use the StorCenter ix2-dl near water. Do not spill liquid on or into the StorCenter ix2-
dl .
5. Do not place the StorCenter ix2-dl on an unstable surface.
6. Do not place the StorCenter ix2-dl near or on a radiator or heat register.
7. Openings in the StorCenter ix2-dl are provided for fans and air ventilation and should not be
blocked or covered. Make sure the StorCenter ix2-dl has ample ventilation (at least 6 inches
or 127 mm) in front and behind the unit. Do not place the StorCenter ix2-dl near or on a
radiator or heat register.
8. Do not walk on the power cord or allow anything to rest on it.
9. There is a danger of explosion if the battery is incorrectly replaced. Replace only with the
same or equivalent type recommended by the equipment manufacturer. Dispose of used
batteries according to local, state, regional, and federal regulations.
Under any of the following conditions, unplug the StorCenter ix2-dl from the wall outlet and contact
technical support:
•
The power cord or plug is damaged.
•
Liquid has been spilled into the device.
•
The device does not function properly when the operating instructions are followed.
•
The device was dropped or the exterior enclosure is damaged.
156