Accessing The Switch For The First Time; Connecting The Switch To A Configuration Terminal; Connecting A Db9-To-Rj45 Console Cable - H3C S5170-EI Series Installation Manual

Accessing the switch for the first time

Connecting the switch to a configuration terminal

The S5170-EI series and S5570S-EI series switches each provide a serial console for connecting to
a configuration terminal.
In Figure 31, the switch is connected to a configuration terminal (PC as an example) from the serial
console port.
Figure 31 Connecting the switch to a configuration terminal
As shown in
configuration terminal.
Table 12 Connection methods and console cables
Connection method
Using the serial console
port for connection
The signal pinout for a DB9-to-RJ45 console cable depends on the vendor of the cable. To avoid
abnormal configuration terminal display, use a serial console cable provided by H3C. For more
information, see
the RJ-45 connector is the same as that shown in

Connecting a DB9-to-RJ45 console cable

CAUTION:
Follow these guidelines when you connect a DB9-to-RJ45 console cable:
• Identify the mark on the serial console port and make sure you are connecting to the correct port.
• The serial ports on PCs do not support hot swapping. To connect a PC to an operating switch,
first connect the PC end. To disconnect a PC from an operating switch, first disconnect the switch
end.
Table 12, two types of console cables can be used for connecting the switch to a
Console cable type
DB9-to-RJ45 console
cable
USB-to-RJ45 console
cable
Table 8. To prepare a serial console cable yourself, make sure the signal pinout for
Configuration
terminal-side
connector
DB-9 female connector
USB connector
Table 13.
1
Switch-side
connector
RJ-45 connector
RJ-45 connector