Table of Contents
Advertisement
OSD Menu
Sub Menu
1
Vector Scope
50
Enable
Target
Position
Size
1
Pixel Value Check
Enable
H Position
V Position
Reset Position
Chromaticity Diagram
Configures various settings for the vector scope. Vector scope displays the intensity of color signals
and hue with the horizontal axis showing the color difference signal Cb and the vertical line showing
Cr.
(Cb, Cr) = (0, 0)
On, Off
Switches the vector scope On, Off.
75%
Sets the target.
100%
75%+100%
Bottom Left
Selects the display position.
Bottom Right
• This setting becomes invalid in the [Multi View (Dual)] display.
Large, Middle, Small
Sets the size of the display.
Measures and displays the RGB value of the specified pixel (cursor) position. When [Gamma/EOTF]
is set to [SMPTE ST 2084 (PQ)] or [Hybrid Log-Gamma], the brightness value is also displayed.
• The non-constant value is displayed even if [2020 Constant Luminance] is set to [Constant].
On, Off
Switches the pixel value check On, Off.
1 to 4096 (960)
Sets the pixel position (horizontal).
1 to 2160 (540)
Sets the pixel position (vertical).
Normal
Sets operation when the RESET button is pressed.
Around Peak
Luminance
[Normal]: Resets the value to the default value.
[Around Peak Luminance]: Moves closer to the area of peak luminance
On, Off
Switches the chromaticity diagram On, Off.
[On]: Displays the chromaticity diagram. The chromaticity diagram is
ž [Color Gamut]: ITU-R BT.2020, ITU-R BT.709
ž [ Gamma/EOTF]: 1.0, 2.2, 2.35, 2.4, 2.6, SMPTE ST 2084 (PQ),
Setting Options (Bold: factory default)
(Cb, Cr) = (255, 255)
Red
Magenta
Yellow
Blue
Cr
Green
Cyan
Cb
inside the display image.
displayed only when [Color Gamut] and [Gamma/EOTF] are set as
shown below.
Hybrid Log-Gamma
Advertisement
Table of Contents
