Table of Contents
Advertisement
INSTALLATION - LOCATION
The MCW100C,E can be mounted on either side of the
machine, oriented according to the location of the reference
surface or stringline. It may be used with a right angle grade
follower, Part number KG04003, or straight tubular follower,
Part number KG07002.
The right angle follower may be attached to the MCW100C,E
hub horizontally, at a 45° angle downward, or at a 45°
upward. (See Figure 3.) The flat on the hub should be parallel
to the grade reference.
Figure 3.
The follower may be attached at a 45° angle downward.
(See Figure 4.)
Figure 4.
The follower may be attached at a 45° angle upward. (See
Figure 5.) and the follower should be positioned toward the
operator panel.
When the straight tubular follower is used for steering control
(see Figure 6), the MCW100C,E hub should be directly
above the stringline. Note: When the right angle follower is
used, the transducer shaft must be mounted perpendicular
to the direction of travel. When the straight tubular follower is
1825
used, the transducer shaft must be parallel with the direction
of travel.
1826
5
Figure 5.
Figure 6.
1827
1828
BLN-95-9013
Advertisement
Table of Contents
