Removing And Replacing The Oven Door And Glass Panes - Asko OT86331BG Instructions For Use Manual

Cleaning and maintenance

Removing and replacing the oven door and glass panes

INFORMATION!
To replace the door, follow the reverse order. If the door does not open or close properly, make
sure the notches on the hinges are aligned with the hinge beds.
WARNING!
The oven door hinge can close with considerable force. Therefore, always rotate both safety
levers to the support when fitting or removing the appliance door.
Soft door closing and opening
(depending on the model)
Oven door is fitted with a system that dampens the door closing force, starting at the a 75°angle. It
allows simple, quiet, and gentle opening and closing of the door. A gentle push (to a 15° angle
relative to the closed door position) is enough for the door to close automatically and softly.
40
1 First, fully open the door (as far as it will go).
2 Oven door is attached to the hinges with
special supports that also include safety
levers. Rotate the safety levers towards the
door by 90°. Slowly close the door to a 45°
angle (relative to the position of the fully closed
door); then, lift the door and pull it out.
Oven door glass pane can be cleaned from
the inside, but it has to be removed from the
appliance door first. First, proceed as
described under item 2, but do not remove it.
3 Remove the air guide. Hold it on the left-
and right-hand side of the door with your
hands. Remove it by slightly pulling it towards
you.
4 Hold the door glass at the upper edge and
remove it. To the same for the second and third
glass pane (depending on the model).
5 To replace the glass panes, observe the
reverse order.