FingerTec i-Kiosk 100 User Manual page 26

11 • ACCESS
Using The terminal as Door Access
The i-Kiosk 100 can be connected to door access accessories like electromagnetic
locks and doorbolts to control access to doors. FingerTec provides all kinds of door-
lock accessories which can be viewed at accessory.fingertec.com. In Access, you can
configure 4 items which are explained below. To access to Access: Menu > User >
Access > Access Control Parameters.
How Long It Takes Before The Door Locks Again
This value is the time period for the door to lock again after unlocking for a successful
verification. The default value is 10 seconds and the range is between 1-10.
Delaying Door Sensor
This function only works if a door sensor is available. When a door is not closed for a
specified time, the sensor will trigger the alarm system. Specify the time of the delay.
The default value is 10s, and the range is from 0-99s. Choose your preferred value.
Choosing Door Sensor Type
There are two types of door sensors available for door access which are Normally
Open (NO) and Normally Close (NC). Once a door sensor is connected to the system,
you have to choose the door sensor type. Default is None.
Delaying Alarm
This function only works when there is an alarm system installed with the i-Kiosk 100.
You can define the amount of time that the door is not closed before the i-Kiosk 100
triggers the alarm system. Input the value in seconds. The default value is 30s.
26 CONTENTS