Table of Contents
Advertisement
5. Click Next to start the wizard.
6.
Select Search for a suitable driver for my device and click Next.
7. Verify the driver found on the CD is dm602bus.inf and click Next.
Note: If Windows doesn't locate the driver automatically, you have to browse for the
driver. It is in the [CD-ROM drive letter]:\DM602v1.0\USB\ folder.
8. Click Finish.
The USB driver is installed.
WARNING: Once you finish installing the USB driver, you MUST complete the
process by installing the Ethernet driver.
Next you need to install a special Ethernet driver for the modem, called NETGEAR PC-
attached Gateway, using the wizard that now appears on screen.
9. Click Next to start the wizard.
10. Again, select Search for a suitable driver for my device and click Next.
11. Verify the driver found on the CD is dm602eth.inf and click Next.
Note: If Windows doesn't locate the driver automatically, you have to browse for the
driver. It is in the [CD-ROM drive letter]:\DM602v1.0\USB\ folder.
12. If you get queried about a Microsoft digital signature, click Yes.
13. Click Finish.
14. Check the setup.
Check the Setup
•
The Power and Internet lights should be lit.
•
For an Ethernet connection, the Ethernet light should be lit and may
blink to show network activity.
Note: If the Ethernet connection is a 100 Mbps connection, the light is green. If it is
a 10 Mbps connection, the light is yellow. If the Power, Internet or Ethernet light
isn't lit, go to Troubleshooting on page 11.
•
For a USB connection, the USB light should be lit and may blink
to show network activity.
Note: If the Power, Internet or USB light isn't lit, go to Troubleshooting on page 11.
6
Advertisement
Table of Contents
