Table of Contents
Advertisement
Biometra TMS
6
Operation
6.1
Switching the device on and off
Switching the device on
Switching the device off
6.2
Overview of basic software functions
Starting the software
Starting the software in an-
other language
ð The multimeter is connected to the mains supply and the PC via the mains cable and
the USB cable.
ð The measuring tree is connected to the multimeter.
ð The software is installed on the PC.
} Use the power button on the housing front to turn the multimeter on.
} Boot the PC.
} Use the shortcut in the Start menu or on the PC's desktop to launch the software.
ü After a 30-minute warm-up time, the device is ready for operation.
} Exit the software by closing the window.
} Shut down the PC.
} Use the power button on the device front to turn the multimeter off.
ü The device is switched off.
The software guides the user through the calibration process in simple steps. Various
configuration options ensure that the operator can customize the software according to
their needs and visualize results.
Use the shortcut on the desktop or in the Start menu to launch the software.
The software is started in the language set for the operating system it was installed on.
If you want to start the software in a different language, you have the option to enter a
command line parameter in the software link. To do this, proceed as follows:
} Select the shortcut for the installed software on the desktop or in the Start menu.
} Open the shortcut menu and click Properties.
} Open the tab Shortcut.
} Add the following command to the specified link in the input field under Target :
– -language=de (German software interface)
– -language=en (English software interface)
ü When using this link to launch the software the next time, it is started in the
specified language.
If the software is not available in the desired language, the system will automati-
cally start the English version of the software.
Operation
19
Advertisement
Chapters
Table of Contents
