Installing Blades - Martec Ariel Series Manual

INSTALLING BLADES

Insert blades one at a time through slots in the motor housing. Secure each blade
with three screws and washers as provided, through the opening in the light disc.
(See Fig 4)
Once you have finished installing all four (4) blades, either screw on the bottom
plate (if you have the MAF114 model, See Fig 5) or install lamp and glass shade (if
you have the MAF1142 model, See Fig 6).
Warning: Do not mix blade sets from one fan to another. If only one blade is damaged
you are still required to replace with a full new set. Do not overtighten the blade
screws as this may cause creaking noises which are not covered under warranty.