Table of Contents
Advertisement
G
COMMISSIONING AND SETTINGS
Introduction
G.1
CAUTION
Make sure the appliance is
connected to a water
drainage system, a power
socket, and to the oven
via the oven/hood
Interface cable.
Switch the oven on as indicated in the Installation
Manual (chap. G "COMMISSIONING AND
SETTINGS").
CAUTION
During operation, pay
attention to the hot areas
of the outer surface. Do
not place objects on the
outlets located at the
upper rear of the
appliance.
G.2 Oven settings
G.2.1 Single oven setting
In the case of installing the hoods, 922718,
922719 or 922720, follow these procedures when
switching on the oven for the first time, set the
parameter "347 Hood" on "Level 4", following the
procedure:
-
AL01 IM_HO_L1_L2_L3_L4
with TOUCH Oven (see annex document).
-
AL02 IM_HO_L1_L2_L3_L4
with DIGIT Oven (see annex document).
G.2.2 Stacking ovens mode setting
In the case of installing the hoods, 922721 or
922722,
•
on MASTER oven follow the previous G.2.1
and setting the parameter "347 Hood" on
"Level 4;
•
on SLAVE oven, when switching on for the
first time, set the parameter "347 Hood" on
"Level 3", following the procedure:
-
AL01 IM_HO_L1_L2_L3_L4
with TOUCH Oven (see annex document).
-
AL02 IM_HO_L1_L2_L3_L4
with DIGIT Oven (see annex document).
G.2.3 Correct oven setting check
The previous procedures must be completed in
order to ensure correct operation of the hood and
to allow its use.
The checking procedure consists of 2 main steps:
1. Only for Level 4 Hood, check that the hood
symbol is present on the oven interface (Touch
Screen Panel); or
2. test hood operation by switching the oven on
and start a test program. Simulate oven door
opening and closing: the fan should change
speed.
21
Advertisement
Table of Contents
