Table of Contents
Advertisement
7.1.5 Radio control's Battery charge
The radio control battery is a critical part of the machine. If the battery
is weakly charged, the machine cannot be controlled. For this reason,
2 batteries are provided for safety. It is strongly recommended to char-
ge both batteries before use
ATTENTION:
If the battery have low charge the engine will stop
7.1.6 Check the cutting blades
The blade rotates at high speed, so abnormal wear or damage to a blade can cause the
machine to vibrate excessively. In addition, hitting a stone or other hard object lying in
the field can make the blade lose its sharpness. For this reason, it is necessary to check
the condition of the knife and especially the fasteners (screws, washers and bushings)
before use. The reorder codes for the individual components are displayed to facilitate
replacement.
How to check the blade
The knife rotates at high speed, so abnormal wear or damage to a knife can cause seve-
re vibrations to the machine. To check the knife, Park the machine in a flat ground; stop
the engine and remove the starting key. Lift and secure the front of the machine in order
to accede easely to the blades. Avoid a precarious and unsafe position. If the machine
falls, it could crush you and cause you serious injuries.
- Check that the blade rest is straight and not bent.
- Check that the blades are regular and not deformed
- Check whether the fastening screws are properly tightened (do not exceed the
maximum tightening torque of 130 Nm)
- Check that the blades are sharp enough
34
7 - MAINTENANCE
895-306-005
6203173
9051010
9031014
SECTION 7 - MAINTENANCE
TORQUE 130 Nm
96 lbf ft
TORQUE 160 Nm
118 lbf ft
Fig. 26
314813
6202542
6201855
6202543
Advertisement
Table of Contents
