Table of Contents
Advertisement
7.1.3 Fuel tanks
Refueling is often not an easy and safe operation in the
work area, so it is advisable to check the fuel level before
starting the operation. A full tank allows 6 hours of auto-
nomy, so fill both tanks and start with tank 1 by turning the
tap to the correct position. See Fig. (24)
The reserve sensor is on tank 1 and is therefore only
signaled when you should switch to the second tank. No
further fuel level is provided.
7.1.4 Check the crawler tension and their conditions
It is important to check the condition of the tracks to prevent them from coming out of
the guides while you are working.
New
If their tension is not sufficient upon inspection, check that the tracks are not damaged or
worn. A loose tracks can easily come out from its seat.
New
If the play between the frame and the tensor lock is higher than 4mm it have to be com-
pensated by the Compensating washer. Compensating washers are supplied with the
machine, which enable the clamping lock to compensate for the play and to perform its
function again. It is very easy to assemble and is shown in Fig. 25
7 - MAINTENANCE
...After 100 hours
5mm
30 hours
Fig. 25
SECTION 7 - MAINTENANCE
Insert the spacer
Fig. 24
33
Advertisement
Table of Contents
