Table of Contents
Advertisement
5.3 ENGINE STOP (Fig. 10)
To switch off the engine, press the red alarm but-
ton at any time (Fig. 10 (O)). The engine suddenly
stops. Shortly after stopping, remember to release
the alarm switch in its normal position. The engine
can also be switched off by the alarm button on top
of the machine (Fig. 7 (L)), by turning off the star
key (Fig. 7 (I)) or anytime the radio connection with
the remote control is interrupted.
NOTE: If the connection to the radio control is lost, the engine switches off.
NOTE: It is recommended that the machine be moved on level ground, whenever pos-
sible, before stopping the engine. In the event of an emergency stop, restart the engine
as soon as possible and place the machine on a flat surface suitable for parking.
5.4 DRIVE (Fig. 13)
Check that the lever (8) is set in the UPPER position.
This lever reverse the motion. Move the Joystick (G Fig.10) FORWARD
gradually and continuously. The machine will move ahead. The machi-
ne can be easily controlled by a finger that controls both speed and di-
rection. It is possible to reverse the Joystick function when the machine
moves forward and towards you (Fig 13).
5.5 WORK IN THE SLOPE
It is advisable to work in the longitudinal way on slopes. At the end
of the way there is no need to turn as the machine works in both
directions. We therefore recommend the route shown in Fig. 14 on
the right. If it is necessary to work with the path shown on the left
in Figure 14, the transmission components will overheat and the
working speed will be significantly lower.
IMPORTANT: When working on a slope, it is necessary to lock the
track tensioner according to Chapter 7.2.9.
TRACK DERAILMENT
22
SECTION 5 - INSTRUCTIONS FOR A SAFE USE
5-SAFE USE
Fig. 14
Fig. 12
N
Fig. 13
Advertisement
Table of Contents
