STIEBEL ELTRON DEM 6 Operation And Installation Instructions Manual page 11

2. Installation Instruction

 
• Route the power cable through the cable
entry in the back panel.
• Hook in the appliance cover with the heater
at the bottom.
• Click the heater into place using the snap
fastener.
• Secure the appliance cover with the cover
fixing screws.
Tap installation
• Install the tap. For this, also observe the tap
operating and installation instructions.
Material losses
!
• When making the connections,
counter the torque on the appliance using a
spanner; see chapter "Installation alterna-
tives / Undersink installation"
Pressure-tested tap
Note
• Fit the 1/2 connection hose pro-
vided.
STIEBEL ELTRON
for the qualified installer
4.2.2 Oversink installation, non-pressurised,
with nonpressurised tap

Tap installation
• Install the tap. For this, also observe the tap
operating and installation instructions.
Appliance installation
• Fit the appliance to the tap with the water
connections.
4.2.3 Connecting the power supply
DANGER Electrocution
Carry out all electrical connection
and installation work in accordance with
regulations.
DANGER Electrocution
Ensure that the appliance is earthed.
Ensure the appliance can be separated from
the power supply by an isolator that discon-
nects all poles with at least 3 mm contact
separation.
Material losses
!
Take note of the type plate. The
specified voltage must match the mains
voltage.
11