Network with a DHCP Server
To install the switch in a network with a DHCP server, proceed as follows:
1. Connect the GS108T Smart Switch to a DHCP network.
2. Power on the switch by connecting its AC-DC power adapter.
3. Install the SmartWizard Discovery utility on your computer.
4. Start the SmartWizard Discovery utility.
5. Click Discover for the SmartWizard Discovery utility to find your GS108T Gigabit Smart
Switch. You should see a screen similar to that shown below.
.
Figure 1-1
6. Make a note of the displayed IP address assigned by the DHCP server. You will need this
value to access the switch directly from a web browser (without using the SmartWizard
Discovery utility).
7. Select your switch by clicking on the line that shows it. Then click the Web Access button.
The discovery utility displays a login window similar to the following:
Getting Started with Switch Management
GS108T Smart Switch Software Administration Manual
v1.0, May 2007
1-3