Table of Contents
Advertisement
HP OAP modules fall into three categories: FIC-OAP modules (for HP
•
MSR50 routers), MIM-OAP modules (for HP MSR30 routers), and
MIM-OAPS modules (also for HP MSR30 routers). FIC-OAP modules are
hot-swappable. You can install or remove a FIC-OAP module while the
HP MSR50 router is on. The MIM-OAP module and MIM-OAPS module
are not hot-swappable. You must turn off the HP MSR30 router before
installing or removing the MIM-OAP or MIM-OAPS module.
CAUTION:
To avoid Lync SBM host exception, shut down the Lync SBM host before
•
you unplug the FIC-OAP module when the HP MSR50 router is powered
on.
To avoid Lync SBM host exceptions, shut down the Lync SBM host and
•
turn off the HP MSR30 router before you remove the MIM-OAP or
MIM-OAPS module.
Installing the module
If you install the module in an unused slot, use a Torx T-10 or flat-bladed
1.
screwdriver to unscrew the screws in the cover plates over the slot where
you will install the module. Store the cover plates for possible future use.
Hold the module by its bulkhead, taking care not to touch the metal
2.
connectors or components on the boards.
Open the extractor handles.
3.
Insert the module, aligning with the guides in the slots, and slide it into
4.
the slot until it is fully inserted.
Once the module is fully inserted, use the extractor handles to set it
5.
completely.
Tighten the screws.
6.
3
Advertisement
Table of Contents
