Table of Contents
Advertisement
Enter the oap connect command in system view of the MSR.
3.
You are redirected to the SBM. The system prompts "Connected to
OAP!" appears.
Enter i after the prompts SAC>.
4.
You can view the initial management IP address, mask, and gateway
assigned by the DHCP server.
If the HP MSR SBM has received a self-assigned IP address beginning
with 169.254, check the network configuration to make the DHCP
server assigns a valid IP address.
Setting the initial management IP address from the HP MSR SBM CLI
To set the initial management IP address:
Enter the command i 13 152.67.95.26 255.255.0.0 152.67.0.254 as
1.
shown in the figure below.
11
Advertisement
Table of Contents
