Figure 3-4. Configuration Through The Console Interface - NETGEAR ProSafe FSM7326P Hardware Installation Manual

Figure 3-4. Configuration through the console interface

The login name is "admin" and there is no password assigned. We strongly recommend that you enable an admin
password to secure access to the switch management function. After you are logged in, the, the screen should show
(FSM7326P)> show sysinfo
prompt. Enter " " to display the management CPU's IP address. The switch is shipped
using DHCP by default to automatically receive its IP address from a DHCP server on your network. To manually set a
static IP address, you must first disable DHCP as follows:
(FSM7326P) >config network protocol none
Changing protocol mode will reset ip configuration.
Are you sure you want to continue? (y/n)y
After the system prompt returns, enter the following command:
(FSM7326P) >config network parms 192.168.1.100 255.255.255.0 192.168.1.1
The example above uses "192.168.1.100" for the IP address and "192.168.1.1" for the gateway IP address. You should
substitute your own IP addresses in the command line above.
If you want to use your Web browser or telnet to manage your switch, note the IP address on the Sysinfo page. To
use your Web browser, simply type the IP address in the URL address bar and press enter. If you want to use an
SNMP management application, you need to note the IP address and configure the SNMP settings in your switch so
that it will respond to SNMP requests. This configuration can be done through either the console or Web browser GUI.
Page 17 of 23