NETGEAR ProSafe FSM7326P Hardware Installation Manual page 22

Switch Integrity
If required, verify the integrity of the switch by resetting it. To reset the switch, use the Tools> Reset
command or remove AC power from the switch and then reapply AC power. If the problem continues,
contact NETGEAR technical support. In North America, call 1-888-NETGEAR. If you are outside of North
America, please refer to the support information card included with your product.
Auto Negotiation
The 10/100/1000 Mbps ports negotiate the correct duplex mode and speed if the device at the other end of
the link supports auto negotiation. If the device does not support auto negotiation, the switch only
determines the speed correctly and the duplex mode defaults to half-duplex.
The gigabit port on the Gigabit module negotiates speed, duplex mode, and flow control, provided that the
attached device supports auto negotiation.
Page 22 of 23