Maintenance - ESAB Sentinel A60 User Manual

Carefully inspect the welding helmet before each use for worn or damaged parts. Replace any
worn or damaged parts only with approved ESAB components as listed in the spare parts list
contained in this User Manual.
ESAB recommends a use period of 5 years. The duration of use depends on various factors such
as use, cleaning, storage and maintenance. Frequent inspections and replacement if helmet is
damaged are recommended.
REPLACING THE FRONT COVER LENS
Replace the front cover lens if it becomes scratched or damaged. Press the semicircle lens
retention button on the external side adjacent to the external grind mode button (right side as
worn), and remove the front cover lens carefully. When replacing with a new front cover lens,
make sure to assemble from the side opposite first, and then snap the lens into the lens retention
button side. Please avoid placing your helmet face down when not in use. This helps
lengthen the lifespan of the front cover lens.
REPLACING THE INSIDE COVER LENS
Replace the inside cover lens if it is damaged.
Lift the lens at the recess below the Auto-Darkening filter. The inside cover lens will flex upward
and release from the cartridge.
REPLACING THE AUTO-DARKENING FILTER (ADF)
1. Remove the external "Grind" button's retainer screw, located on the right-side edge of the
battery compartment inside the helmet shell and behind the "Grind" button.
2. Push the locks on both sides of the ADF, push the "Grind" button inward by pressing it
firmly, then the ADF can be removed from the shell.
3. When installing a new ADF, install the Grind button from inside the shell, press it firmly
then put the ADF into the shell and lock the Auto-Darkening filter into place.
CLEANING
Clean helmet by wiping with a soft, dry cloth. Clean the cartridge surfaces regularly. Do not use
strong cleaning solutions.

MAINTENANCE