Step 3: Checking The Installation - NETGEAR FS728TS Hardware Installation Manual

Hardware Installation Guide for the Prosafe Stackable Smart Switch FS700TS Series
5. Tighten the screws with a #2 Phillips screwdriver to secure the switch in the rack.
Figure 3-1

Step 3: Checking the Installation

Before applying power check the following:
1. Inspect the equipment thoroughly.
2. Verify that all cables are installed correctly.
3. Check cable routing to make sure cables are not damaged or creating a safety hazard.
4. Ensure all equipment is mounted properly and securely.
Installation 3-3
v1.0, December 2005