Checking The Installation - NETGEAR ProSafe JGSM7224 Hardware Installation Manual

Installing the Switch in a Rack
To install the switch in a rack, you need the 19-inch rack-mounting kit supplied with your
switch.
1. Attach the supplied mounting brackets to the side of the switch.
2. Use the provided Phillips head screws to fasten the brackets to the sides of the switch.
Figure 1.
3. Tighten the screws with a No. 1 Phillips screwdriver to secure each bracket.
4. Align the bracket and rack holes. Use two pan-head screws with nylon washers to fasten
each bracket to the rack.
5. Tighten the screws with a No. 2 Phillips screwdriver to secure the switch in the rack.

Checking the Installation

Before you apply power, perform the following checks:
1. Inspect the equipment thoroughly.
2. Verify that all cables are installed correctly.
3. Check cable routing to ensure that cables are not damaged and will not create a safety
hazard.
4. Be sure that all equipment is mounted properly and securely.
ProSafe™ 24-Port Managed Switch JGSM7224
Hardware Installation
11
Mounting
bracket