Step 3: Checking The Installation - NETGEAR GS724TPS - ProSafe - Gigabit Stackable PoE Smart Switch Hardware Installation Manual

GS700TPS Smart Switch
5. Tighten the screws with a #2 Phillips screwdriver to secure the switch in the rack.
Figure 2-1
Note: Always install devices from the bottom of the to the top. This will prevent the rack
from over balancing and toppling over.

Step 3: Checking the Installation

Before applying power perform the following:
• Inspect the equipment thoroughly.
• Verify that all cables are installed correctly.
• Check cable routing to make sure cables are not damaged or creating a safety hazard.
Installation
v1.0, April 2009
2-3