Led Designations - NETGEAR FS728TS Hardware Installation Manual

Hardware Installation Guide for the Prosafe Stackable Smart Switch FS700TS Series

LED Designations

Port LEDs
The following table describes the port LED designations.
Table 1. Port LEDs Non-POE Device
Table 2-1. PORT LEDs on Non-PoE Devices
Port
24/48 10/100M Ports—One
LED/Port
4 Gigabit Copper Ports—
Two LED's/Port on Jack
2 SFP Ports—One LED/Port SFP Link/ACT LED
2-10
LED Designation
Link/ACT/SPD LED Off : No 10/100Mbps link is established on the port.
Solid Green: A valid 100Mbps link is established on
the port.
Flashing Green: Packet transmission or reception is
occurring on the port at 100Mbps.
Solid Yellow: A valid 10Mbps link is established on
the port.
Flashing Yellow: Packet transmission or reception is
occurring on the port at 10Mbps.
Left LED Link/ACT/ Off : No 10/100/1000Mbps link is established on the
SPD LED: port.
Solid Green: A valid 1000Mbps link is established on
the port.
Solid Yellow: A valid 10/100Mbps link is established
on the port.
Flashing Green: Packet transmission or reception is
occurring on the port at 1000Mbps.
Flashing Yellow: Packet transmission or reception is
occurring on the port at 10/100Mbps.
Right LED Stack Green: Stack port has a valid link connection.
LED (Combo port Off: Stack port does not have a valid link connection.
group/Copper port
group):
Off: No link is established on the port.
Solid Green: A valid link is established on the port.
Flashing Green: Packet transmission or reception is
occurring on the port.
v1.0, December 2005
Introduction