Step 3: Checking The Installation - NETGEAR GS724AT - ProSafe Gigabit Smart Switch Hardware Installation Manual

GS700AT Hardware Installation Guide
5. Tighten the screws with a #2 Phillips screwdriver to secure the switch in the rack.
Figure 2-1
Note: Always install devices from the bottom of the to the top. This will prevent the rack
from over balancing and toppling over.

Step 3: Checking the Installation

Before applying power perform the following:
• Inspect the equipment thoroughly.
• Verify that all cables are installed correctly.
• Check cable routing to make sure cables are not damaged or creating a safety hazard.
• Ensure all equipment is mounted properly and securely.
Installation
v1.0, December 2007
2-31