Hardware Installation Guide for the Prosafe Stackable Smart Switch FS700TS Series
If any item is missing or damaged, contact the place of purchase immediately.
Panel Layout Guide
FS728TS Front Panel
The NETGEAR FS728TS Smart Switch is a 24-Port 10/100M Stackable Smart Switch with 4
Gigabit Ports. Each RJ45 port automatically senses the line speed and negotiates duplex mode
operation with the link partner.
The following figure shows the NETGEAR FS728TS Smart Switch front panel:
Figure 2-3
1. (1a-1m) LEDs for the top row of 10/100M ports (odd-numbered ports 1-23)
2. (2a-2m) LEDs for the bottom row of 10/100M ports (even-numbered ports 2-24)
3. LED for the top-most SFP port (port 25F)
4. LED for the bottom-most SFP port (port 26F)
5. Reset button
6. Stack ID LED
7. Power LED
8. Stack Master LED
9. 24 RJ-45 connectors for 10BASE-T and 100BASE-TX (ports 1-24)
10. 2 Gigabit Interface Converter SFP slots for SFP modules (ports 25F and 26F)
11. 4 RJ-45 connectors for 10BASE-T, 100BASE-TX and 1000BASE-T (ports 25T, 26T, 27, and
28)
12. Factory Defaults button
Introduction
2-7
v1.0, December 2005