Features - NETGEAR FS516 Installation Manual

The Model FS516 switch can be used to partition a 10 Mbps or 100 Mbps network to enhance the
capacity of the network to support advanced applications. In addition, the switch provides a link
between traditional 10 Mbps networks and faster 100 Mbps networks. By installing a Model
FS516 switch, a user can connect any 10 Mbps or 100 Mbps device to the switch without worrying
about the running speed of the device. The Model FS516 switch provides a built-in upgrade path;
you can remove a 10 Mbps connection and replace the connection with a 100 Mbps connection
with little or no change to the rest of the network.
The Model FS516 switch can be effectively used to join multiple 100 Mbps Fast Ethernet
segments and to extend the reach of the network. Copper-based Fast Ethernet networks have a
network diameter of up to 200 meters. The Model FS516 switch can be used to join these 200
meter segments to enable them to function as a single logical network. With one Model FS516
switch, the reach extends to 400 meters. With two switches, the reach extends to 600 meters. For
an illustration of using the switch to extend a network, refer to
Because the Model FS516 switch is an ISO media access control (MAC) layer device, the switch
is network protocol independent and compatible with all popular networks such as the Internet or
TCP/IP, NetWare, DECnet, Microsoft NETBEUI, and LANTASTIC.

Features

The Model FS516 switch has the following key features:
• Sixteen automatic speed sensing (autosensing) 10/100 Mbps Ethernet ports to provide fast
information exchange, resource sharing, and client or peer-to-peer communication using
simple Category 5 unshielded twisted pair (UTP) cable
• Automatic address learning function to build the packet-forwarding information table
The table contains up to 4,000 MAC addresses (that is, the switch can support networks with
as many as 4,000 devices).
• Switch-selectable autonegotiating or full-duplex mode of operation
Full-duplex mode doubles throughput of point-to-point connections by letting individual ports
transmit and receive concurrently when the other end also supports full-duplex mode. The
default is half-duplex if the connected device does not support N-way negotiation. The duplex
toggle switch can be set to full-duplex if the connected port is operating at full-duplex mode.
• Wire-speed filtering and forwarding to provide "traffic cop" function by directing traffic to the
appropriate route without slowing down the traffic
• Store-and-forward forwarding node to minimize erroneous packets on the network
Introduction
Installation Guide for the Model FS516 Fast Ethernet Switch
Figure 3-3 on page 3-4.
1-3