Network Adapter Cards; Configuration; Switch Integrity - NETGEAR FS516 Installation Manual

Installation Guide for the Model FS516 Fast Ethernet Switch
Table 5-1. Troubleshooting Information (continued)
Symptom
One or more components
are malfunctioning.
A segment or device is
not recognized as part of
the network.

Network Adapter Cards

Make sure the network adapter cards installed in the PCs are in working condition and the software
driver has been installed.
Configuration
If problems occur after altering the network configuration, restore the original connections and
determine the problem by implementing the new changes, one procedure at a time. Make sure
that cable distances, repeater limits, and other physical aspects of the installation do not exceed
the Ethernet limitations.

Switch Integrity

If required, verify the integrity of the switch by resetting the switch. Turn power to the switch off
and then back on. If the problem continues and you have completed all the preceding diagnoses,
contact your NETGEAR point-of-sale representative.
5-2
Cause
All system components
are not properly installed.
One or more devices are
not properly connected or
cabling does not meet
Ethernet guidelines.
Solution
Test the components in an alternate environment
where all other components are functioning
properly.
Verify that the cabling is correct (refer to
Appendix C, "Cabling Guidelines"). Be sure all
cable connectors are securely positioned in the
required ports. Straight-through cables should be
used for all standard twisted pair connections.
Make sure all devices are connected to the
network. Equipment may have been accidentally
disconnected.
Troubleshooting