Operation; Removing/Inserting The Battery; Checking The Battery Charge Level; Recharging The Battery - Parkside PHKSA 12 B3 Original Instructions Manual

GB
bottom protective hood and spring
do not work properly, have the saw
serviced before using it. Damaged
parts, sticky deposits or accumulations
of chips cause the bottom protective
hood to work with a delay.
c) Only open the bottom protective hood
by hand for special cuts, such as
"plunge and angular cuts". Open the
bottom protective hood with the pull
lever and release it as soon as the saw
blade cuts into the workpiece. For all
other sawing, the bottom protective
hood should work automatically.
d) Do not place the saw on the work
bench or the floor if the bottom
protective hood is not covering the
saw blade. An unprotected saw blade
that is still running will move the saw
in the direction opposite of the cutting
direction and cut whatever is in its
way. Pay attention to how long the saw
blade remains running.

Operation

Removing/inserting the
Battery
1. To remove the battery (4) from the ap-
pliance, press the release button (3) on
the battery and pull out the battery.
2. To insert the battery (4), place it on the
guide track and push it into the appli-
ance. It will audibly snap in.
Checking the battery
charge level
The battery's (4) charge level is indicated
by the charge state indicator (18).
The LEDs indicate the battery's charge
level, when the device is in operation.
30
Press and hold the power button (2).
red-yellow-green => Battery fully charged
red and yellow => Battery half charged
red
=> Battery needs

Recharging the battery

Allow a hot battery to cool before
charging.
Charge the battery (4) when only
the red LED on the level indicator is
illuminated.
1. Remove the battery (4) from the appli-
ance.
2. Plug the battery charger (
mains outlet.
3. Insert the battery (4) in the charging
compartment of the battery charger
( 27).
4. After charging is complete, a green
light will be illuminated permanently.
You can now disconnect the charger
( 27) from the mains supply.
5. Unplug the battery charger (
from the mains.
Checking the function of
the protective hood
• Pull the pull lever for the protective
hood ( 23) back as far as it will
go. The protective hood (9) must move
freely without jamming and jump back
to the original position automatically
when the pull lever for the protective
hood ( 23) is released.
• Always keep the protective hood
(9) free of sawdust to keep it from
jamming the mechanism.
to be charged
27) into a
27)