Table of Contents
Advertisement
PRODUCT ASSEMBLY
ASSEMBLING THE JUICER PARTS
Before using your Juicer for the first time, wipe Juicer parts with a warm, damp cloth, then wipe
clean with a damp cloth. Do not wash the Drive Assembly. Dry with a soft cloth. See the
"Care and Cleaning" section.
1.
Slide the Pulp Chute onto the bottom of the bowl.
2.
Slide the gasket into place behind the Pulp Chute.
3.
Put the Screen Wiper Basket into the bowl.
4.
Place the screen of your choice into the Screen Wiper Basket with the alignment marks
directly above the Pulp Chute.
5.
Place the Auger/Blade Assembly inside the screen.
ATTACHING THE JUICER ASSEMBLY TO THE STAND MIXER
1.
Turn the Stand Mixer OFF (0) and unplug.
2.
For Stand Mixers with a hinged attachment hub cover: Flip up to open.
For Stand Mixers with a removable attachment hub cover: Turn the attachment knob
counterclockwise to remove attachment hub cover.
3.
Insert the Juicer attachment into the attachment hub. Rotate attachment back and forth if
necessary. The pin on the attachment housing will fit into the notch of the hub rim when in
proper position.
4.
Tighten attachment knob until the Juicer attachment is completely secured to Stand Mixer.
5.
Place a container under both the juice spout and Pulp Chute.
Plug into an earthed outlet.
Do not remove earth prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or
electrical shock.
6.
Plug the Stand Mixer into an earthed outlet.
WARNING
Electrical Shock Hazard
5
Advertisement
Table of Contents
