Table of Contents
Advertisement
Information on the display panel
Display
Õ
r
E lights up
The symbol Û
flashes
E:36
alternating with
-10
E:35
alternating with
-10 (Suitable for spe-
cial models)
Other displays
Cause/Remedy
Flashes fast + signal: The door was opened and the water level is too high.
■
Close the door, continue the programme with Start/Pause A button or
select 0 Spin.
Flashes slowly: The door lock temperature is too high to open the door. Wait
■
approx. 30 seconds until the door lock temperature cools down.
Flashes (no water supply): Water tap turned on? Filter in the water supply is
■
blocked?
~ "Filter in the water supply is blocked" on page 40
If an additional water filter has been installed (depending on the model), check
for contaminants and clean if required ~ separate installation and cleaning
instruction for water filter.
Is the supply hose kinked or trapped?
Lights up (low water pressure): For information only. This will not affect the
■
programme progress. The programme duration is extended.
The childproof lock is activated – deactivate it.
Run the Û Drum Clean programme to clean and care for the drum and the outer
tub.
Notes
Run the programme without laundry.
■
Use washing powder or a detergent containing bleach. To prevent foaming,
■
only use half the amount of detergent recommended by the detergent manu-
facturer. Do not use detergent designed for woollens or delicates.
Switching the drum care information signal on/off.~ Page 36
■
Drain pipe or water drain hose is blocked. Clean the drain pipe and the water
■
drain hose.
Drain pipe or water drain hose is caught or jammed. Ensure that the drain pipe
■
and the water drain hose are not kinked or trapped.
The drain pump is blocked.
■
~ "Drain pump is blocked" on page 39
The drain hose at the siphon is blocked.
■
~ "The drain hose at the siphon is blocked" on page 40
The water drain hose is connected too high. Install the water drain hose at a
■
maximum height of 1 meter.
~ "Hose and cable lengths" on page 16
There is water in the base trough, the appliance is leaking. Turn off the tap. Call
customer services.
Turn the programme selector to Off, wait for five seconds and then switch it on
again. If the display appears again, call customer services.
Faults and what to do about them
en
43
Advertisement
Table of Contents
