Check the Strip Loading Station
Ensure that the strip loading station and push bar are clean and in the correct
position. If contaminants are present, remove and clean the push bar, the
platform, and the moving table.
Change the Starting Sequence Number
This number increments with each strip placed onto the analyzer. If necessary,
use this procedure to change the number.
1. Select
.
SEQ #
A numeric keypad displays.
2. Enter the new sequence number.
Change individual digits as needed:
a. Select
Move Left
change.
b. Enter the correct number.
Select
to reset the number.
00001
3. Select
.
Enter
Change the Technician Identification
You can activate the Tech ID option during analyzer setup. Refer to Tech ID‚
page 102 for more information.
1. Select
.
Menu
2. Select
.
Tech ID
A numeric keypad displays.
3. Enter an identification number of up to 13 digits.
a. Select
to enter alphabetic characters.
A-Z
b. Select
Enter
4. Select
to save the Tech ID.
Enter
Print Information
1. Select
.
Menu
2. Select
to print:
Print
•
the ID list if a loadlist exists in memory
•
confirmation of the last calibration
•
a report of the setup parameters
18
or
to move the cursor to the digit to
Move Right
to return to the numeric keypad.
Clinitek Advantus Operator's Guide