Pci/Plug And Play Setup - BOSER Technology HS-7000 Manual

4.8 PCI / Plug and Play Setup
This section describes configuring the PCI bus system. PCI, or
Personal Computer Interconnect, is a system that allows I/O devices to
operate at speeds nearing the speed the CPU itself uses when
communicating with its own special components. This section covers
some very technical items and it is strongly recommended that only
experienced users should make any changes to the default settings.
AMIBIOS SETUP – PCI / PLUG AND PLAY SETUP
(C)2001 American Megatrends, Inc. All Rights Reserved
Plug and Play Aware O/S
Clear NVRAM
PCT Latency Timer (PCI Clocks)
Primary Graphics Adapter
Allocate IRQ to PCI VGA
PCI IDE BusMaster
OffBoard PCI IDE Card
OffBoard PCI IDE Primary IRQ
OffBoard PCI IDE Secondary IRQ
Plug and Play Aware O/S:
If enabled, BIOS will configure only PnP ISA boot devices (i.e., all
PnP ISA cards with boot flag set) then configure all other devices.
If disabled, the BIOS will configure all devices without following
any sequence.
Clear NVRAM on Every Boot:
When this option is set to Yes, the system can auto clear NVRAM.
PCI Latency Timer (PCI Clocks):
This option specifies the latency timings (in PCI clocks) of PCI
devices installed in the PCI expansion slots. The available
settings are 32, 64, 96, 128, 160, 192, 224, and 248.
Allocate IRQ to PCI VGA:
Set this option to Yes when allocating an IRQ to the VGA device
on the PCI bus. The available settings are Yes, and No.
42
No Available Options:
No No
32 Yes
AGP
Yes
Disabled
Auto
Disabled
Disabled
ESC:Exit
PgUp/PgDn: Modify
F1:Help
:Sel
F2/F3:Color