General Safety Rules - Electrolux LIBERO POINT Installation And Operating Manual

Hide thumbs

Table Of Contents

Table of Contents

correct sizing of the switch or plug, refer to the absorbed current specified on the

appliance data plate (32A).

• If the power cable is damaged, it must be replaced by the Customer Care Service or in

any case by specialised personnel, in order to prevent any risk.

• Verify that a safety circuit breaker is installed between the power cable of the appliance

and the mains electric line. The contact opening max. distance and leakage current

must comply with the local safety regulations.

• After making the connection, with the appliance running check that the power supply

does not fluctuate by ±10% the rated voltage.

• Be sure to power the equipment with systems that are protected against overvoltage;

the manufacturer declines all responsibility for effects due to anomalies induced by the

electrical supply system.

• The machine that can operate at 50 or 60 Hz does not need any setting by the user.

Electrical connection for appliances with plug

• To connect to the power supply, insert the power cable plug in the corresponding mains

socket, first making sure:

• the socket has an efficient earth contact and the mains voltage and frequency match

that given on the dataplate. In case of any doubts regarding the efficiency of the earth

connection have the system checked by specialised personnel;

• the system power supply is arranged and able to take the actual current absorption and

that it is correctly executed according to the regulations in force in the country of use;

• The plug must be accessible after positioning the appliance in the place of installation;

• The plug must be in a position always visible to the operator performing the intervention

during maintenance operations;

Electrical connection for appliances with cable without plug

• The connection point has an efficient earth contact and the mains voltage and frequency

match that given on the data plate. In case of doubts regarding the efficiency of the earth

wire, have the system checked by specialised personnel;

• the appliance must be permanently connected to the power supply, respecting the

polarities:

– brown/black/gray: phase

– yellow/green: earth

– blue: neutral;

• An H07RN-F type power cable (code 60245 IEC 66) is used for the permanent

connection to the mains; in case of replacement, use a type with at least these

characteristics. When replacing the cable, the earth wire must be kept longer than the

live and neutral wires.

• The differential thermal-magnetic switch must be lockable in the open position in case of

maintenance.

• If using a plug, it must comply with the national installation rules. The plug must also be:

– accessible after the appliance has been positioned

– in the place of installation;

– in a position always visible to the operator performing the intervention during

maintenance operations;

A.8