Installation - Siemens WT47W5W0 Manual

de
safety instructions

installation

:
warning
Risk of electric shock / risk of fire /
damage to property and
equipment!
Improper installation of the
device is dangerous. Make sure
that:
The mains voltage at your
■
socket and the voltage
information on the device
(Device label) must match.
The connection values and
the required fuse are
specified on the rating plate.
The device may only be
connected to AC voltage via
■
a properly installed
protective contact socket.
This socket must be freely
accessible at all times. The
mains plug and the
■
protective contact socket
must match
and the grounding system
must be installed according to
regulations.
The installation must have
■
a sufficiently large cable
cross-section.
6th
The power plug must be
■
freely accessible at all times.
If this is not possible, a
switch (2-pole disconnection)
must be installed in the fixed
installation in accordance
with the regulations for the
Electrical installation.
When using a residual
■
current circuit breaker, only
one type with the symbol
z can be used. Only this
symbol guarantees
compliance with the current
regulations.
:
warning
Risk of electric shock / risk of fire /
damage to property and
equipment!
Modifying or damaging the
power cord of the device can
lead to electric shock, short
circuit or fire due to
overheating.
The power cord must not be
kinked, crushed or modified
and must not come into
contact with heat sources.