de
Device help
3
Device help
Disruptions
Hi l to the device
Device does not start
Wrinkling.
Water comes out.
Displayed program duration
changes during dry washing and adapts the program duration (except time programs).
operation.
Laundry does not dry
properly or is still too damp.
Program does not start
Drying time too long.
Humidity in the room increases. Ventilate the room sufficiently.
36
Cause / remedy
Check the power plug and the fuses.
Load exceeded or wrong program selected for a type of
■
fabric. You will find all the information you need in the
program table. ~ Page 22
Take the laundry out of the drum as soon as it is dry.
■
Lying in the drum causes creases.
The device could be at an angle. Align the device. ~ Page 13
No mistake. The moisture sensor determines the residual moisture in the
At the end of the program, warm laundry feels more humid than it
■
actually is. Spread out the laundry and let it cool down. Adjust the
dryness level or increase the level of dryness. This extends the drying
■
time while maintaining the same temperature.
Select the time program for drying laundry that is still
■
damp. Select the time program for a small load.
■
Maximum load of a program is not
■
exceed. ~ Page 22
Clean the moisture sensor in the drum. A fine layer of lime or
■
residues from detergents and care products can be
deposited on the sensor and its function
affect. ~ Page 33
Drying was interrupted by a power failure, a full
■
condensation container or by exceeding the maximum
drying time.
Also note the tips on washing. ~ Page 26
A notice:
Make sure, that
the door is closed
■
the childproof lock is deactivated for 3
■
seconds on start / pauseÜwas pressed
■
A notice:
Is a program delay through Completed in set,
the program starts at a later time.
The appliance can be soiled with lint. This causes a
■
longer drying time. Remove the fluff. ~ Page 31
A blocked or not freely accessible air inlet on the device
■
can extend the drying time. Keep the air inlet free.
An ambient temperature lower than 15 ° C and higher than 30 °
■
C can extend the drying time.
Insufficient air circulation in the room can increase the drying time.
■
Ventilate the room sufficiently.