Advertisement
Wall plate
Screws
Figure 11
Finishing the Installation
Step 1. Tuck connections neatly into ceiling outlet box.
Step 2. Slide the canopy up to ceiling and over the 2 screws on hanger bracket.
Rotate canopy clockwise, next, while holding the canopy with one hand, slide the
canopy cover over the screws and rotate clockwise until tight. Note: adjust the
canopy screws as necessary until the canopy and canopy cover are snug. (Fig. 12)
Switch
Screws
4
3
2
1
0
Outlet box
WARNING
MAKE SURE TAB AT BOTTOM OF HANGER
BRACKET IS HANGER PROPERLY SEATED IN
GROOVE OF HANGER BALL BEFORE
ATTACHING CANOPY TO BRACKET. FAILURE
TO PROPERLY SEAT TAB IN GROOVE COULD
CAUSE DAMAGE TO ELECTRICAL WIRING.
Outlet box
Hanger
bracket
Figure 12
Screws
Canopy
Canopy
cover
6.
Advertisement
