Mercedes-Benz C-Class Saloon 2022 Owner's Manual page 406

Pump up the tyre again.
#
After a maximum of ten minutes the tyre pres-
sure must be at least 200 kPa (2.0 bar/
29 psi).
& WARNING Risk of accident due to the
specified tyre pressure not being attained
If the specified tyre pressure is not attained
after the specified time, the tyre is too badly
damaged. The tyre sealant cannot repair the
tyre in this instance.
The braking and driving characteristics may be
greatly impaired.
Do not continue driving.
#
Consult a qualified specialist workshop.
#
If, after ten minutes, a tyre pressure of 200 kPa
(2.0 bar/29 psi) has been attained:
& WARNING Risk of accident from driving
with sealed tyres
A tyre temporarily sealed with tyre sealant
impairs the handling characteristics and is not
suitable for higher speeds.
Adapt your driving style accordingly and
#
drive carefully.
Do not exceed the maximum speed limit
#
with a tyre that has been repaired using
tyre sealant.
Observe the maximum permissible speed of
#
80 km/h for a tyre sealed with tyre sealant.
Affix the upper section of the TIREFIT sticker
#
to the instrument cluster in a location where it
will be easily seen by the driver.
* NOTE Staining from leaking tyre sealant
After use, excess tyre sealant may leak out
from the filling hose.
Therefore, place the filling hose in the
#
plastic bag that contained the TIREFIT
kit.
+
ENVIRONMENTAL NOTE Environmental
pollution caused by environmentally irre-
sponsible disposal
Tyre sealant contains pollutants.
Breakdown assistance 403
Have the tyre sealant bottle disposed of
#
professionally, e.g. at a Mercedes-Benz
Service Centre.
Switch off the tyre inflation compressor.
#
Unscrew the filling hose from the valve of the
#
defective tyre.
Stow the tyre sealant bottle and the tyre infla-
#
tion compressor.
Pull away immediately.
#
Stop driving after approximately ten minutes
#
and check the tyre pressure using the tyre
inflation compressor.
The tyre pressure must now be at least
130 kPa (1.3 bar/19 psi).
& WARNING Risk of accident due to the
specified tyre pressure not being attained
If the specified tyre pressure is not reached,
the tyre is too badly damaged. The tyre seal-
ant cannot repair the tyre in this instance.
The braking and driving characteristics may be
greatly impaired.