Mercedes-Benz C-Class Saloon 2022 Owner's Manual page 145

142 Light and sight
The high beam will switch off automatically in the
following cases:
At speeds below 25 km/h
R
If other road users are detected
R
If street lighting is sufficient
R
%
The system's optical sensor is located behind
the windscreen near the overhead control
panel.
▌Switching Adaptive Highbeam Assist on/off
Switching on
Turn the light switch to the à position.
#
Switch on high beam using the combination
#
switch.
If Adaptive Highbeam Assist is activated,
the _ indicator lamp will light up on the
driver's display.
Switching off
Switch off high beam using the combination
#
switch.
Adaptive Highbeam Assist Plus
▌Adaptive Highbeam Assist Plus function
& WARNING Risk of accident despite Adap-
tive Highbeam Assist Plus
Adaptive Highbeam Assist Plus does not react
to:
road users without lights, e.g. pedestrians
R
road users with poor lighting, e.g. cyclists
R
road users whose lighting is obstructed,
R
e.g. by a barrier
On very rare occasions, Adaptive Highbeam
Assist Plus may fail to recognise other road
users with their own lighting, or may recognise
them too late.
In these, or in similar situations, the automatic
high beam will not be deactivated or will be
activated despite the presence of other road
users.
Always observe the road and traffic con-
#
ditions carefully and switch off the high
beam in good time.
Adaptive Highbeam Assist Plus cannot take into
account road, weather or traffic conditions.
Detection may be restricted in the following
cases:
In poor visibility, e.g. fog, heavy rain or snow
R
if there is dirt on the sensors or the sensors
R
are obscured
Adaptive Highbeam Assist Plus is only an aid. You
are responsible for adjusting the vehicle's lighting
to the prevailing light, visibility and traffic condi-
tions.