Mercedes-Benz C-Class Saloon 2022 Owner's Manual page 192

Configuring DYNAMIC SELECT in the multimedia
system
Multimedia system:
© Settings Vehicle
4 5 5
DYNAMIC SELECT
5
Setting drive program I
Select = Individual.
#
Select and set a category.
#
Switching the reset display on/off
Activate or deactivate Ask when
#
%
This function must be activated for each user
profile separately. Only when this function is
activated will the drive program and ECO
start/stop setting for the previous journey be
saved for the respective user profile.
Function on: the next time the vehicle is started a
prompt appears asking whether the last active
drive program should be restored. If the ECO
start/stop function was deactivated, an additional
prompt appears asking if the function should
remain deactivated.
%
The prompt only appears if the previously
active settings deviate from the standard set-
tings.
Function off: the next time the vehicle is started
the A drive program is set automatically. The
ECO start/stop function is activated automati-
cally.
Configuring DYNAMIC SELECT in the MMS (plug-
in hybrid and electric vehicles)
Multimedia system:
starting.
©
4 5
DYNAMIC SELECT
5
Setting drive program I
Select = Individual.
#
Select and set a category.
#
Setting the H drive program
Select Hybrid.
#
Select Route-based
#
If route guidance is active and the
based option has been activated, the electri-
Settings Vehicle
5
or Standard.
Route-
Driving and parking 189
cal energy is distributed intelligently over the
entire route. In built-up areas, electric mode is
preferred, while on the motorway the combus-
tion engine is used.
With the Standard option, the vehicle drives in
its standard drive program (Î
n Hybrid). There is no distribution of elec-
trical energy over the entire route. The high-
voltage battery is exhausted and the vehicle is
then driven by the combustion engine.
Switching the reset display on/off
Activate or deactivate Ask when
#
%
This function must be activated for each user
profile separately. The drive program for the
respective user profile of the last driver is only
stored if this function is activated.
Function on: the next time the vehicle is started a
prompt appears asking whether the last active
drive program should be restored.
%
The prompt only appears if the previously
active settings deviate from the standard set-
tings.
Electric or
starting.