Mercedes-Benz C-Class Saloon 2022 Owner's Manual page 166

To protect against overheating, the seat heating
may be temporarily deactivated after it has been
switched on repeatedly.
%
This function is available only for vehicles with
a high-voltage battery or some models with a
48 V on-board electrical system.
The air inside the vehicle can be heated, ventila-
ted or cooled to the set temperature when the
vehicle is parked.
Plug-in hybrid: When the vehicle is connected to
power supply equipment, priority will be given to
charging the high-voltage battery to a specified
minimum state of charge.
The running time of pre-entry climate control may
be reduced in the following circumstances:
Plug-in hybrid: The vehicle is not connected to
R
power supply equipment.
The high voltage battery or the 48 V battery is
R
not fully charged.
Plug-in hybrid: With active pre-entry climate con-
trol, the state of charge of the high-voltage battery
may be reduced, even if the charging cable con-
nector is inserted.
If present, seat ventilation will be activated in
cooling and ventilation modes.
Depending on the vehicle's equipment, the follow-
ing functions will be activated in heating mode, if
available:
Seat heating
R
Steering wheel heater
R
Mirror heater
R
Rear window heater
R
Windscreen heater
R
When the set temperature changes, climate con-
trol mode will switch automatically as follows:
from heating mode to ventilation or cooling
R
mode, or
from cooling mode to ventilation or heating
R
mode, or
from ventilation mode to heating or cooling
R
mode
Climate control 163
▌Setting pre-entry climate control for departure
time via the multimedia system
Multimedia system:
Climate menu Pre-entry climate ctrl
4 5
Setting the departure time
%
Plug-in hybrid: The set departure times are
used for the vehicle's pre-entry climate con-
trol and for predictions regarding the approxi-
mate state of charge and range at the time
selected. Additional information on the charg-
ing settings: ( page 343).
/
Select Edit departure time ´.
#
Select a departure time or set a new depar-
#
ture time.
Setting the repeat days
Select Edit departure time ´.
#
Set the desired departure time and select the
#
corresponding weekdays on which this depar-
ture time is to apply.
Press OK to confirm.
#