Table of Contents
Advertisement
8. Check that the following fi gure message has been displayed,
and input "y", and press the Enter key.
(Using 2-byte characters, it may not be displayed correctly)
Input
The firmware update tool has booted.
The firmware of drive f: will be updated.
After the new firmware is copied to drive f:
the new firmware will be loaded and the unit will reboot.
Close SonicStage before starting this program.
Run this program? (y/n)
9. The following fi gure message is displayed, and the destination/
model settings is performed on the WALKMAN main unit.
(Using 2-byte characters, it may not be displayed correctly)
C:\NWA30_XXX_XXXX_ChangeDestination_V1.00>_
Firmware update will start.
Copying the new firmware image [NW_WM_FW.UPG]...
Copying NW_WM_FW.UPG...
1 file(s) copied.
Ready to start fupdate SCSI command !
execscsitest f: "0xfc 0 0x04 0x64 0x62 0x6d 0x6e 0 0 0 0 0"
Firmware update has started.
The firmware update tool will close.
10. The WALKMAN main unit reboots automatically after the
destination/model settings are performed.
11. After rebooting, check that the USB connection screen is dis-
played on the liquid crystal display of the WALKMAN main
unit.
(The settings is completed when the USB connection screen is
displayed.)
12. Input "exit" and press the Enter key to close the command
prompt application software.
C:\NWA30_XXX_XXXX_ChangeDestination_V1.00>exit
This completes the destination/model settings.
Please proceed to the "2-2. Initial Settings" on the following.
2-2. Initial Settings
Perform settings that are appropriate for body color. After the des-
tination/model settings, be sure to perform the initial settings.
Used folder name (tool):
NWA30_Color_Init_Setting_V1.00
Note 1: Use the folder of the color name that conforms to body color from
in the folder.
Folder name
BLACK
BLUE
PINK
RED
YELLOW
Procedure:
1. Connect the WALKMAN main unit to PC (personal computer)
by the USB cable (WM-PORT).
(The power supply of the WALKMAN is automatically turned
on)
Note 2: If leave the connection status in the previous step, this step is not
necessary.
– The following steps will all operate on the PC (personal com-
puter) –
2. Check how the WALKMAN is recognized by MSC connec-
tion, and the check of the drive letter is necessary.
(at this example, it is "F:")
3. Open the folder that the destination/model settings tool.
4. In the non-selected state for fi les in the folder, and put a cursor
to blank space in the folder.
In the folder of the initial settings tool
Input
5. The right-click while pressing the Shift key in the state of step
4.
NW-A35/A35HN/A36HN/A37HN
Body color
Charcoal Black
Viridian Blue
Bordeaux Pink
Cinnabar Red
Lime Yellow
USB cable
drive letter
– Continued on next page –
blank space
cursor
7
Advertisement
Table of Contents
