Connecting The Fastmile 5G Gateway 3.2; Starting The Fastmile 5G Gateway 3.2 - Nokia FastMile 3.2 User Manual

Setting up the FastMile 5G Gateway 3.2

Connecting the FastMile 5G Gateway 3.2

Place the FastMile 5G Gateway 3.2 on a flat surface, such as a tabletop or similar;
close to a window, and near an electrical outlet.
Minimize the number of obstructions as much as possible.
The power adapter mounts directly into the electrical outlet in the wall.
Note: Ensure that no cables are blocking the air flow on the bottom of the FastMile 5G
Gateway 3.2 to avoid overheating.

Starting the FastMile 5G Gateway 3.2

After the FastMile 5G Gateway 3.2 is connected to a power source, start the device
by pressing the On/Off button located on the backside of the unit.
One or more LEDs on the top of the gateway will turn on soon.
There are 5 LEDs:
The FastMile 5G Gateway 3.2 starts searching for the best 5G connectivity. The
status LED and the 5G LED start to blink and all signal LEDs are solid ON to indicate
that the device is booting up.
When the signal strength LEDs go off, the booting-up phase is completed and the
status LED is lit RED to indicate the signal search procedure.
Note: The signal search may take a few minutes.
Wait until the status LED is green. This indicates connectivity to 5G or 4G network.
20
• status LED -in the middle of the circle
• 5G LED - above the status LED
• signal strength LEDs (3) - above the 5G LED
© 2022 Nokia. Nokia Confidential Information
Use subject to agreed restrictions on disclosure and use.
User Guide
3TG-02292-AAAA-TCZZA-02