Motorola MVME2600 Series Installation And Use Manual page 5

Hide thumbs Also See for MVME2600 Series:

All Motorola PWBs (printed wiring boards) are manufactured by UL-recognized

manufacturers, with a ßammability rating of 94V-0.

This equipment generates, uses, and can radiate electro-

magnetic energy. It may cause or be susceptible to

electro-magnetic interference (EMI) if not installed and

WARNING

used in a cabinet with adequate EMI protection.

If any modifications are made to the product, the

modifier assumes responsibility for radio frequency

interference issues. Changes or modifications not

expressly approved by Motorola Computer Group

could void the userÕs authority to operate the

equipment.

European Notice: Board products with the CE marking comply with the

EMC Directive (89/336/EEC). Compliance with this directive implies

conformity to the following European Norms:

EN55022 (CISPR 22) Radio Frequency Interference

EN50082-1 (IEC801-2, IEC801-3, IEEC801-4) Electromagnetic

Immunity

This board product was tested in a representative system to show

compliance with the above mentioned requirements. A proper installation

in a CE-marked system will maintain the required EMC/safety

performance.

For minimum RF emissions, it is essential that you implement the

following conditions:

1. Install shielded cables on all external I/O ports.

2. Connect conductive chassis rails to earth ground to provide a path for

connecting shields to earth ground.

3. Tighten all front panel screws.