Esu PowerPack Mini Instruction Manual

58923 LokSound 5 nano DCC
AUX3 (Logic Level)
Fig. 3: PowerPack connected to LokSound 5 nano DCC
58741 LokSound 5 micro DCC Kato USA
The AUX6 output must be set to «PowerPack Control»:
CV 31 = 16
CV 32 = 0
CV 315 = 31
Fig. 4: PowerPack connected to LokSound 5 micro DCC Kato USA
4
GND (Ground)
ESU
Power
Charge
Pack
U+
The AUX3 output must be set to «PowerPack Control»:
CV 31 = 16
CV32 = 0
CV291 = 31
GND (Ground)
ESU
Power
Charge (AUX6)
Pack
U+
54671 ESU PowerPack Mini
54672 ESU PowerPack Maxi
Instruction manual
1 . E d i t i o n , A p r i l 2 0 2 2 1 . E d i t i o n , A p r i l 2 0 2 2
1. WEEE-Declaration
Disposal of obsolete electrical and electronic equipment (as practised in the European Union and other European countries with
dedicated collection systems). This mark on the product, the packaging or the relevant documentation indicates that this
product must not be treated like household waste. Instead this product should be disposed of at a suitable
collection point for recycling of electrical and electronic appliances. Thus you contribute to avoid negative
im- pact on the environment and people's health that could be caused by inappropriate disposal. Recycling
of materials contributes to preserve our natural resources. For more information regarding recycling of this
product, please contact your local administration, your waste collection service or the dealer / shop where
you purchased this product.
2. Important notes – Please read this chapter first
We congratulate you to your purchase of an ESU PowerPack. This manual would like to show you step
by step how to connect the ESU PowerPack to your ESU decoder. So a request:
Please read this manual carefully. Although the ESU PowerPack has been designed as a robust device
an incorrect connection may lead to faults or even to the destruction of the device. Avoid any «costly»
experiments.
• The ESU PowerPack is exclusively intended for use with model train layouts only. It may only be opera-
ted with the components listed here. Any other use is not permitted.
• Any wiring has to be carried out while power is disconnected.
• Adhere to the wiring principles as outlined in this manual for wiring any external components.
• Avoid mechanical force or pressure on the ESU PowerPack and the selected ESU Decoder.
• Do not expose to wet and humid conditions.
• No cable should ever touch any metal part of the locomotive .
• Make sure that no wires are squeezed or cut by the model's transmission parts when reassembling the
engine.
P/N 01322-26143
1