Backyard Discovery Bay Pointe Owner's Manual page 15

SLIDE ASSEMBLY
M78
SLIDE BRACE - W4L13298
5/8"x3 3/8"x14 1/4" (16x86x362)
(1)
NOTE:
PLACE SECOND SLIDE RAIL ASSEMBLY OVER THE TOP OF THE SLIDE BED AND M78 CENTER SLIDE BRACES. INSERT
THE SLIDE BED AND CENTER SLIDE BRACES INTO THE SLIDE CAVITY. MAKE SURE SLIDE BED IS COMPLETELY IN
THE SLIDE CAVITY. USE A RUBBER MALLET TO FULLY SEAT THE SLIDE BED INTO THE SLIDE CAVITY.
USING AN 1/8" DRILL BIT, DRILL PILOT HOLES IN EACH INDENTATION ALONG EACH SIDE RAIL. THERE SHOULD BE 12
INDENTATIONS ON EACH RAIL. BE SURE TO DRILL THROUGH THE SLIDE RAIL AND THE SLIDE BED. THEN SECURE
WITH THE PROVIDED HARDWARE.
FAILURE TO INSERT SLIDE BED COMPLETELY AND SECURED MAY RESULT IN
INJURY OR AMPUTATION. EXPOSED SLIDE EDGES CAN BE SHARP AND BECOME
A LACERATION HAZARD IF THE SLIDE IS NOT PROPERLY ASSEMBLED.
M78
(x1)
SLIDE BRACE
6 FT SLIDE RAIL LEFT
H100090 SCREW PFH
(16)
8x2 1/2"
403
(x1)
6 FT SLIDE RAIL RIGHT
402
(x1)
15
STEP 2
A6P00403
6 FT SLIDE RAIL RIGHT
(1)
A6P00402
6 FT SLIDE RAIL LEFT
(1)
TIP:
A HELPER IS REQUIRED FOR THIS STEP.
090
(x16)
SCREW - 2 1/2"