Chapter 4 Configuration; Configuration Steps - GE VersaMax IC200SET001 User Manual

Configuration
Chapter
4
The VMSE can be configured using remote or local methods. Either use an
ASCII terminal or a terminal emulation program to locally access the serial
port, or use a Telnet connection to configure the unit over the network.
The VMSE configuration is stored in nonvolatile flash memory and is
retained without power. The configuration can be changed any time. The
VMSE performs a reset after the configuration has been changed and stored.

Configuration Steps

The following steps need to be done, in the order listed, to configure the
VMSE for use. These steps can be done via the serial port or over the
network using Telnet.
•
•
•
GFK-1852B
Set the Network Configuration - IP Address, Gateway Address, and
Network Mask.
Load appropriate firmware if needed - SRTP/SNP, PassThru,
Modbus TCP/RTU.
Configure Channel for application - Depends on firmware option
chosen. See Chapter 1 for firmware option details.
4-1