Advertisement
5. Steaming hanging items.
Vertical steam jet function is ideal for
steaming curtains, suits and delicate fabrics.
Hang item on a hanger, hold iron at a
distance of 10~20 cm and press steam jet
button. te krijgen (B).
6. 3-way Auto-OFF.
If iron is left unattended on soleplate or on
the side, it turns off after 30 seconds. If left
unattended on the heel, it turns off after 8
minutes. To turn on, just begin to iron again.
Cleaning
(do not use any detergent)
1. Always store iron on its heel rest. To clean
exterior surfaces, use a damp soft cloth and
wipe dry. Do not use any chemical solvents,
as these will damage the surface.
12
2. Self-cleaning function. Hold iron over a
sink. Fill with water. Heat up iron. Move
steam button to selfcleaning position, hold
for 5 seconds to empty water from steam
holes. Release button to stop self-cleaning
function.
3. Cleaning the soleplate. Do not use scouring
pads or harsh cleaners on the soleplate as
these will damage the surface. To remove
burnt residue, iron over a damp cloth while
iron is still hot. To clean the Glissium
TM
soleplate, simply wipe with soft damp cloth
and wipe dry.
Troubleshooting
Problem
Possible cause
Connection problem
Soleplate is not
heating even though
iron is turned on.
Temperature control is
in MIN position.
Not enough water in
tank.
Steam control is
selected in non-steam
Iron does not produce
position.
steam.
Selected temperature is
lower than that specfied
to use with steam.
Not enough water in
Spray function does
not work.
tank.
Steam jet function was
used very frequently
within a short period.
Steam jet and vertical
steam jet function
does not work.
Iron is not hot enough.
The tank is wet even
The factory product test
though iron is new
would make the
product.
moisture.
Solution
Check main power supply cable,
plug and outlet.
Select adequate temperature.
Fill water tank (see "Getting
started" no 2).
Set steam control between
positions of minimum steam and
maximum steam (see "Ironing
chart").
Select a temperature up to
.
●●●
Fill water tank (see "Getting
started"no 2).
Put iron on horizontal position and
wait before using steam jet
function.
Adjust the proper temperature to
steam ironing (up to
). Put iron in
●●
vertical position and wait until
temperature indicator light turns off.
It's not the product problem so
just use it.
13
Advertisement
